Gallery

Model No. IP40ST
Extending platform trailer with deck specifically designed to carry gas bottles, with pneumatic tyres for a smooth and secure ride

Model No. IP2ST
Small platform trailers specifically designed for limited access on gantry platforms aboard oil rigs, with T handle and towing eye.

Standard Platform
Standard platform trailers with keruing half lap decking for heavy industrial use.

Model No. IP200TT
With a payload of 20,000 kgs this platform trailer has been design with guides to transport crucibles with molten aluminium.

Model No. IP30TT
Platform manufactured with sockets for slot in stanchions for the moving of aircraft parts, also fitted with a plywood deck and rubber overlay to minimise damage during transport.

Nissan Engine Trailer
Nissan Washington plant is a model of working efficiency in practice. Moving engines  power units) between assembly lines is vital to keeping targets. We designed and built trailers to handle up to 10 engines at a time

Model No. IP200TT –
Capacity 20,000 kgs
Manufactured to carry steel coils, specifically designed trailer curtain covered trailer on rollers and hoops to facilitate the loading / unloading
by overhead crane.

Model No. IP50TT –
Box Van Trailer
1 of 3 purpose built trailers for transporting large quantities of stationary / equipment around a large government site.

Model No. IP10ST & IP20ST – Luggage Trailers
These trailers were design specifically for the needs of each of the operators to best facilitate the movement of the baggage around the airport and runway.

Model No. IP100ST –
Tank Trailer
Specifically design for British Aerospace to move aviation kerosene around the site.

Model No. IP20ST
4 of 12 manufactured for Caterpillar these curtain side trailers are used to deliver parts to the production line.

Model No. IP15ST –
Food Trolley Transporters
Designed with a hydraulic
tail lift these box trailers transport upto 5 food trollies at a time around a large  HMP site.

Model No. IP80TT
At over 1,000 kgs each, this trailer was manufactured to carry 5 molten metal boats around the foundry floor, the twin turntable design ensures the manoeuvrability and stability of the payload.

Plant Trailer
Swan-neck trailer used for transporting fork lifts on a large industrial site

Trolley Transporter
With it’s low ground clearance this trailer is purpose built to transport industrial trolleys round the shop floor

Kvaerner
One of the larges trailers we have produced to date. This custom made trailer can handle up to 12m, 34 tonnes at a time. Special hydraulics allow loads to be raised and lowered by up to 200mm 

Model No. IP100SA
(Single Ackerman)
This trailer was designed to transport bag filters for a chemical plant.

Komatsu Dump Truck
Komatsu build some of the world’s largest dumper trucks. Moving the tipper section weighting 21 tonne into Komatsu’s paint shop could have been a problem but, as usual, our designers had the answer. This trailer supports it’s load perfectly, allowing for easy transfer into the factory.

Model No.IP120CS
(Castor Steered)
1 of 9 this trailer was designed and manufactured for Caterpillar
to carry 12 tonne telescopic booms along the production line.

Model No. IP10TA
(Twin Ackerman)
To meet the demands of Nissan’s production this trailer was specifically design to deliver palletised axles to the assembly line.

Model No. IP20CS
(Castor Steer)
Manufactured for Goodyear this trailer was designed with a low ground clearance to allow tyre reinforcement to be ‘rolled on &
off’ for transportation.

Model No. IP20BP
(Battery Powered)
Manufactured for the UK Paper Company for handling calendar rolls, battery powered it has a 2 tonne payload.